The Fordson Tractor Pages Forum

Thanks Sandy

Thanks Sandy - sorry for late reply. I was going to send a photo of the top control unit but can't see where to upload. The top control unit has a unusual fitting screwed into the housing, forward facing and looks like a male push fit connector but this may just be a bodge from a previous life. I on...

Hello does anyone know how and where to connect up a double acting spool valve block as I want to use the Super Dexta this year to operate a Browns 56 bale carrier? Pictures or diagram would be good. Thanks.

OK so all sorted now. Spring I ordered still not arrived so I cut down a draft control spring to 10.5 coils and fitted that. It now allows the position control lever bolt to touch the draft lever and so allows proper adjustment. Replaced piston seal and fitted new filter. Now all hydraulics working ...

Cheers Sandy.
Regards
Garry

Yes thanks for that, worth a try. Spring not arrived yet. I'm replacing hydraulic arm piston seal, there was only one to remove. Parts supplier sent two, one seal and a back up seal but there isn't enough width in the slot on the piston to get both in. Do you know if there should be a back up seal f...

I've measured diameter of coils and ordered from a spring supplier a spring with 10 coils and 50mm long. Worth a try.

Thanks. I would renew the position control spring but no one Ive found sells them. Local dealer says not available anymore. Plenty of draft control springs though.

My Dexta wouldn't lift the arm up beyond halfway so I renewed the pivot pin which had worn almost through. I reassembled everything without altering the adjustments. I then found that although it lifted a little more it still wasn't fully lifting the arms. I've now taken it apart again and have chec...