Just a bit of a curiosity.
This is a gasket to go behind the vapouriser plate of the manifold. It is branded GG (never heard of them) and Made in Australia.
As you can see, it is a copper and steel construction with a very thin layer of some other material.
It would have minimised air leaks, but would not have done a lot for vapourising, as the fuel could have bypassed the maze.
Was this gasket ever offered in other countries?
Eric
[/img]
Vapouriser plate gasket
-
- True Blue
- Posts: 60
- Joined: Fri Jun 13, 2008 4:17 am
- Location: Victoria, Australia
Vaporiser Plate Gasket
Eric,
Saw one of these gaskets a few years ago. It was also marked GG. A chap over Vectis/Quantong area had it, along with a lot of other interesting parts.
Saw one of these gaskets a few years ago. It was also marked GG. A chap over Vectis/Quantong area had it, along with a lot of other interesting parts.
BarryM
-
- True Blue
- Posts: 105
- Joined: Tue Apr 29, 2008 5:44 pm
- Location: Somerset, England, UK
Gasket
Hi,
I believe that this gasket is for the Gas Oil vapouriser which has the shape of the inside of the gasket cut out where the vapouriser plate would go on. I will try to find some pictures.
I believe that this gasket is for the Gas Oil vapouriser which has the shape of the inside of the gasket cut out where the vapouriser plate would go on. I will try to find some pictures.
-
- True Blue
- Posts: 105
- Joined: Tue Apr 29, 2008 5:44 pm
- Location: Somerset, England, UK