E27N P T O

This forum is about the Fordson F, N and E27N Major.

E27N P T O

Postby fizza » Wed Apr 30, 2014 9:30 am

:scratchhead: Am I missing something?
Have just finished changing PTO box to final drive seals, and the shaft output seal.
I had a real fiddle replacing the shaft.
My handbook specifically says that the shaft length is such that it will enter the splines at the front end before the rear bearing enters its housing, however that was not the case here.
I did finally get it in, but could my shaft be too short??http://www.fordsontractorpages.nl/phpbb3/posting.php?mode=edit&f=1&p=41224#

Bob
fizza
Not Quite Blue Yet
 
Posts: 18
Joined: Tue Apr 08, 2014 6:28 am
Location: Warncoort, Victoria. Australia

Return to Fordson F, N and E27N Major

Who is online

Users browsing this forum: No registered users and 1 guest