This may be a bit of a stupid question, but I need both brackets fro the lift arms, the ones that bolt on to the rear axel. Firstly what is the proper name for these, and does anyone have an idea on where to get the things from, found nothing online so far
Or dimensions might be helpful if no where sell
Thanks
Billy
lift arms brackets
-
- Site Governance Team & Expert Team
- Posts: 2082
- Joined: Wed Apr 16, 2008 8:56 pm
- Location: Arnemuiden, The Netherlands
- Contact:
Re: lift arms brackets
there are three different types.
1- one hole for the chain and three holes for the fitting on the rear axle. New Major
2 - two holes for the chain and three holes for fitting. Power Major.
3- one hole for the chain and four holes for fitting. Super Major.
1- one hole for the chain and three holes for the fitting on the rear axle. New Major
2 - two holes for the chain and three holes for fitting. Power Major.
3- one hole for the chain and four holes for fitting. Super Major.
Kind regards, Henk
Fordson New Major February 1957 Mark I
Fordson New Major February 1957 Mark I
Re: lift arms brackets
Sorry henk, I meant the bracket that the link arm actually pivots on, I guess its not really on the axel, its just below the drawbar bracket
-
- Site Governance Team & Expert Team
- Posts: 2082
- Joined: Wed Apr 16, 2008 8:56 pm
- Location: Arnemuiden, The Netherlands
- Contact:
Re: lift arms brackets
I see.
From those there are two types. The normal ones and the model for the Power Major.
Just be patience and keep looking and asking for them.
From those there are two types. The normal ones and the model for the Power Major.
Just be patience and keep looking and asking for them.
Kind regards, Henk
Fordson New Major February 1957 Mark I
Fordson New Major February 1957 Mark I