Page 1 of 1

Oil supply to head

Posted: Sun May 04, 2014 6:19 am
by 1su9pm6aj4
Hi all,

Unfortunately I cannot work much my tractor project due to work right now but next chance, I want to install the head.

Question: is the head gasket supposed to crush the oil supply gasket when installing.? My new head gasket is not cut out to fit around the oil supply gasket, but instead sits on top of it. Is that O K or should I open the hole up a bit?

I have a new copper head gasket that sits on top of the oil gasket also, doesn't make sense the manufacturers did punch a bigger hole but maybe it's not a problem.

Regards

Kerry