Drawbar carrier

This forum is for the Fordson New Major, including the Super Major and the Power Major.
Post Reply
billy
True Blue
Posts: 77
Joined: Tue Apr 21, 2015 10:22 pm
Location: Dorset, England

Drawbar carrier

Post by billy »

Hi guys,
I'm near the end of my restoration, and I'm looking for measurements for the drawbar carrier pin. So this is the long one that is under the back axle. I believe it has a groove in it for locking. Not sure if I massively like that design but still.
When the tractor came to me, it had a thin bit of threaded bar through...not sure that would met the load specs?! :lol:

Thanks!

mathias1
Site Governance Team
Site Governance Team
Posts: 787
Joined: Fri Jul 08, 2016 7:11 pm
Location: Antwerp - Belgium

Re: Drawbar carrier

Post by mathias1 »

Billy,

this is the pin you are looking for:

Image

Image

Thickness is about 24mm, but you can check it on your bracket. The little plate is used to lock the pin in the groove and is bolt on the side of the drawbar.
Fordson Super Major New Performance
County Super 4 built on the Fordson Super Major
Selene built on the Fordson Super Major New Performance with Silvant winch

Roadless63
True Blue
Posts: 261
Joined: Tue May 06, 2008 10:49 pm
Location: Derby/Hants

Re: Drawbar carrier

Post by Roadless63 »

Ive got one of these with the locking plate, drop me a PM if interested. Regards, Ed

Post Reply