Super major hydraulics
Posted: Sun Jul 01, 2018 10:22 am
I have a new major with the stacked additional auxiliary lever and thus independent front and rear hydraulic connections. Good for loader together with tipping trailer.
How should i do this on a super major? The original lever i would like connected to the three point and the auxiliary outlet. And then some additional lever to a front loader that is independent in the rear equipment.
Also I have noticed that two of three four holes for the uppermost pin to the top link are larger and flattened on two sides. How is the original dimension and look of this pin?
How should i do this on a super major? The original lever i would like connected to the three point and the auxiliary outlet. And then some additional lever to a front loader that is independent in the rear equipment.
Also I have noticed that two of three four holes for the uppermost pin to the top link are larger and flattened on two sides. How is the original dimension and look of this pin?