Cold start

This forum is about the Fordson Dexta, Super Dexta and Petrol Dexta.
Post Reply
pottyperkins
Not Quite Blue Yet
Posts: 31
Joined: Thu Aug 06, 2009 10:21 pm
Location: lancashire uk

Cold start

Post by pottyperkins »

It was cold this morning around -7 and its the first time the super dexta needed heat since the engine overhaul, it usually starts ok with pressing in the excess fuel button
What is the correct way to heat it, i gave it a couple of pumps to prime it, heated it ,then another pump, i didnt hear a pop.but it did start but still a bit sluggish
There is a loud pop on my friend fergie fitted with a p3, should the dexta do this?

pjjms
True Blue
Posts: 213
Joined: Tue Dec 15, 2009 10:11 am
Location: Nelson, New Zealand

Post by pjjms »

I believe the correct proceedure is as follows.
1 pump of the primer.
Pre heat for 40 seconds.
While keeping the pre heat on crank the engine at part throttle until it starts.

Mine pops sometimes and I'm sure this is just the fuel ignighting in the manifold.

When I first got mine the air cleaner had too much oil in it so when it went pop it blew oil out the top and all over the bonnet, what a mess. Not a great first start.

Raymondc71
True Blue
Posts: 53
Joined: Tue Jan 05, 2010 10:19 pm
Location: Ireland
Contact:

OIL cleaner

Post by Raymondc71 »

My dexta used to throw up the oil too..I took the oil bath apart and cleaned it with desiel..Filled back up with engine oil and it doesnt do it any more..There was alot of sludge in the oil bath.
Diesel Dexta 1960 Restyle

Post Reply