Rear bearings, shims required and studs

landowner · Post by **landowner** » Mon Oct 11, 2010 9:14 pm

Any help appreciated on this,

Need some shims for the Dexta rear bearings as the old ones broke up on removal.
Also need hub retaining studs as a few of them are useless.

Not going well this Dexta....not well at all

YorkshireDextaMan · Post by **YorkshireDextaMan** » Mon Oct 11, 2010 10:32 pm

Shims from Agriline, You can get the studs and nuts from a CNH dealer, they aint cheap though. or you could try a Fastner factor. although i tried one and they were mostly metric. You should be able to get the number off the bearings so you can shop around for the cheapest. not as expensive as you may think, Try these,
http://simplybearings.co.uk/shop/ Jim

landowner · Post by **landowner** » Mon Oct 11, 2010 11:06 pm

Thanks for that,
I was thinking of using bolts instead of studs but I'll have a go at gettin studs first
didn't know agriline did the shims though I'll bet they arn't cheap.

YorkshireDextaMan · Post by **YorkshireDextaMan** » Mon Oct 11, 2010 11:16 pm

landowner wrote:Thanks for that,
I was thinking of using bolts instead of studs but I'll have a go at gettin studs first
didn't know agriline did the shims though I'll bet they arn't cheap.

.

The shims are the same ones used on a MF 35/ 135 and may not be listed under Dexta. E-Bay is another place . thats where i got mine .
I would not get any shims at all untill you get the bearings fitted and offered up because till then you wont know how many you need.