Lower link arm ball size

This forum is about the Fordson Dexta, Super Dexta and Petrol Dexta.
Post Reply
Phil C
Not Quite Blue Yet
Posts: 10
Joined: Sun Jul 01, 2012 9:10 pm
Location: Near Watton Norfolk

Lower link arm ball size

Post by Phil C »

Hi All
Another little problem I have.
All the ends on my lower link arms were badly worn so I brought new ends and welded on, what I didn't realise is that the ends are different, either they have been put on wrong many moons ago or the pins on the tractor end is wrong.
It looks to me that the implement end cat 1 is 7/8 inch and the tractor end is 3/4 inch, can anybody confirm this please.
And if this is the case I've welded the wrong size ball ends on the tractor end.
If I am thinking right and the tractor end is 3/4 inch does anybody know the agriline part number? I did ring them up but I don't think they knew that I meant.
Cheers Phil :?

PghBill
True Blue
Posts: 168
Joined: Wed Nov 23, 2011 12:24 pm
Location: Pittsburgh,PA.

Re: Lower link arm ball size

Post by PghBill »

Phil C wrote:It looks to me that the implement end cat 1 is 7/8 inch and the tractor end is 3/4 inch, can anybody confirm this please.
Phil,
Sorry to say. It's true. :eyes:
Can't help you with the Agriline part # though.

Category --------- Top Link Pin Diameter--------Lift Arm Pin Diameter
0--------------------5/8 in ------------------------ 5/8 in
1--------------------3/4 in------------------------- 7/8 in

Post Reply