What I found when I took the top cover off
Posted: Sun Apr 05, 2015 8:00 pm
[/URL][/img]
On the left is the control actuator arm. As you can see it has a worn area where the end of the position control linkage was rubbing on it. Does it matter? Do I need to weld it and grind it back.
On the right is the position control pin worn as expected.
I also found the control valve spring front cover slightly bent and dented. Will that need beating out and fixing or will it not matter?
Any advise gratefully received.
Happy Easter everyone.
On the left is the control actuator arm. As you can see it has a worn area where the end of the position control linkage was rubbing on it. Does it matter? Do I need to weld it and grind it back.
On the right is the position control pin worn as expected.
I also found the control valve spring front cover slightly bent and dented. Will that need beating out and fixing or will it not matter?
Any advise gratefully received.
Happy Easter everyone.