Crank end float,
Posted: Sat Apr 18, 2015 8:43 pm
Anyone have a comment on this please. The Dexta manual I have says "Crankshaft end float 0.00225 to 0.01025," Is that like 2thou to 10 thou, ??
Ask because on my rebuild my crankshaft has been reground at sometime +10. its quite ok with just new shells, but noticing excessive crank end float I got a set of 0.75 thrust washers, and on fitting them I could just get in a 2thou feeler , do you think this is too tight , and if I was to sand some off which face of the washer should it be,
Jim.
Ask because on my rebuild my crankshaft has been reground at sometime +10. its quite ok with just new shells, but noticing excessive crank end float I got a set of 0.75 thrust washers, and on fitting them I could just get in a 2thou feeler , do you think this is too tight , and if I was to sand some off which face of the washer should it be,
Jim.