Setting up a PM plough crosshaft
Posted: Sat Aug 23, 2014 6:53 pm
Went to the local vintage club "shine up" today and some one mentioned my cross shaft needed adjusting to get an equal front furrow width (10"). Spent the afternoon tinkering until the plough wouldn't work at all!
Does anyone have a diagram/photo or set of instructions for setting up the cross shaft on a PM 2 furrow?
I came across a Ferguson plough instruction that said adjusting the right hand cross shaft end towards the rear reduced the front furrow width and rotating it forward widened the furrow. Does this work on PMs too?
All contribution gratefully received! (hope to have the plough online tomorrow morning for another session!
PS My major has wheels set to 56"
Does anyone have a diagram/photo or set of instructions for setting up the cross shaft on a PM 2 furrow?
I came across a Ferguson plough instruction that said adjusting the right hand cross shaft end towards the rear reduced the front furrow width and rotating it forward widened the furrow. Does this work on PMs too?
All contribution gratefully received! (hope to have the plough online tomorrow morning for another session!
PS My major has wheels set to 56"