The discs are normally riveted to the axles. I’ve done this twice in the past by warm riveting. It gave no problems.
The disks I have now been heat treatment hardened and at the slightest heating they warp considerably. So warm riveting is not possible. After much searching I found a type of steel that is soft enough for cold riveting, but this way also deform and warp the discs.
I’m getting a bit frustrated about it.
Does anyone have experience with this and what can I do to solve it?
I know that bolting them on is not the right way, but I’m thinking of making a clamp disk with three M10 thread holes and put that in front of the disc and put the bolds in at the axle side. By using LocTide I can hold the bolds in place. Hoping that the discs are staying flat.
Would this work?