HV McKay was one of Australia’s largest agricultural machinery manufacturers for a fair bit of the 20’th century. In 1924 they produced a self propelled header (combine in foreign countries) powered by a Fordson engine. When Fordson production ended in 1928, the headers were fitted with a Wisconsin engine.
http://mview.museum.vic.gov.au/paimages ... /19005.htm
Or the engine on its own
http://mview.museum.vic.gov.au/paimages ... /18996.htm
Now, take a look at this photo
http://mview.museum.vic.gov.au/paimages ... /19004.htm
It shows what looks like a 6 cylinder engine with Fordson attachments. The radiator is obviously drawn in, as the proportions are not right. There is a belt pulley at the rear of the engine, not something used on headers. The most intriguing parts are the sump, which has radius rod lugs, and the front axle/radiator mounting. Now, unless these engines were originally designed as a conversion kit for the Fordson tractor, why put the lugs on the sump. These were not needed on the header.
Can anyone identify this engine? Is it a Wisconsin? What model, size, etc? Was there a conversion kit made by someone using a Wisconsin engine? Did McKay make a conversion kit? Any answers? Anyone? Lots o’ questions!
You will notice a lug on the sump of the 4 cylinder engine. This had a fore and aft stay attached to it. It does not line up with the axle pivot pin, so not used as a radius rod mount.
Eric
A Wisconsin powered Fordson conversion?
-
- True Blue
- Posts: 60
- Joined: Fri Jun 13, 2008 4:17 am
- Location: Victoria, Australia
-
- True Blue
- Posts: 60
- Joined: Fri Jun 13, 2008 4:17 am
- Location: Victoria, Australia
-
- Not Quite Blue Yet
- Posts: 35
- Joined: Sun Apr 20, 2008 3:11 am
- Location: Warwick, Queensland ,Australia
Hi Eric, Between 1963 and 1967 I had a Sunshine 14 foot Auto header powered by a 4 cylinder Wisconsin Motor. In wet conditions or a heavy crop, the motor was very much underpowered. Probably because of this they experimented with different motor conversions. Some were fitted with the Ford V8 flat head motor and they probably would have also tried the 6 cylinder Continental or Chrysler motor which was fitted to the Massey-Harris 102 Senior Tractors. The 6 cylinder in the photo resembles those motors. They definitely did have the Lugs on the Sump as they had a support rod from the lugs across to the header frame like a torsion rod. The crank handle at the front as well as the pulley at the back is not part of the header set-up as you cranked the header at the side of the right angle gearbox, where the circular plate is in the photo. The engine driven Sunshine hay baler had a similar 4 cylinder motor with a front crank-handle. Best regards - Michael