The Fordson Tractor Pages Forum

Good day fellows, I had a chance to bring this over to the machinist who ground the flywheel. He measured the pilot hole in the flywheel to be 2.046 inches. This is .001 inches less than the 52mm bearing I have. He recommends using a bit of emery cloth to polish the transmission input shaft and fit ...

Happy Saturday Fellows,

Following up on that 1x2” bearing. It is loose on the input shaft and falls right through the flywheel. I did confirm the measurements and it is 1x2. Back to the drawing board.

Have a good week,

Paul

Hello and thank you much Fellows, I mic’d the worn input shaft I have, but the OD is less than the 24.99mm ID of the New Holland Dealership bearing. I tried to mic the pilot bearing ID on my flywheel, but my caliper doesn’t have a long enough reach. No new information on possible metric bearings. Af...

Thinking about this more. I wonder if New Holland is supplying a bearing with the idea that the input shaft has some damage. Maybe a 24.99x51.8x15mm bearing works correctly for the preload and the buggered up input shaft needs to be turned down to fit. I’ll mic my old input shaft for curiosity.

mathias1 wrote: ↑

Mon Apr 01, 2024 7:40 pm

I got 62052RSSKF bearing as pilot. it says it is normal clearance. Should I worry?
when I need bearings I always try to order skf or any other good quality brand.

Do you know what your transmission input shaft OD is?

I called Messick’s today (New Holland dealer). They mic’d one of their pilot bearings on hand. The OD was less than 52mm and the ID was slightly less than 25mm. I have seen some Fordson Major pilot bearings listed as 24.99 ID and some 51.8 OD. I’m assuming this bearing was at those measurements. It ...

Thank you for your replies, The bearing I have is stamped 6205Z. The New Holland site lists bearing 28043200 which replaces E1ADDN7600 and E1ADKN7600A. In the description it states 6205Z with dimensions 25x52x15mm. From the Messick’s site it lists the same 28043200 number but also states special int...

Good day fellows, I appreciate this post as it hits home for me. I’m working on a 1954 unit with the single stage clutch. The pilot bearing spun on the transmission input shaft. I have a remanufactured input shaft and purchased a pilot and throw out bearing from the same supplier. The problem I’m se...