The Fordson Tractor Pages Forum

thanks for the suggestions

Some Lucas are both polarities - the one on my positive earth landrover is, but it is only 47 watts

I'll keep looking

many thanks

Hi all
I am struggling to find a positive earth flasher unit which is big enough to run a trailer board
Any suggestions please?

thanks

18mph on tyres which are over inflated is a bit scary and bouncy

Lesson learned there !

For what it is worth, I recently had an IFor Williams livestock trailer stolen. From the poor cctv footage (it was at the limit of range and at night) it took 5 minutes to remove wheel clamp and hitch lock and take enough wall down to lift the gate chain over the post, hitch up and drive off. Anyone...

Thanks all
I have finally got it sussed how it fits together
Refurbished rams are now in my possession
Just need to find time and decent weather to put it all together. However, it is now so wet that any further weight on my land is going to end in getting stuck !

Hi all As my quest for a front loader manual is failing, I wonder if someone could possible post or mail me some photos of how it fits together please? This example, on ebay, is the one I havem although I don't apperar to have the front bar in the picture https://www.ebay.co.uk/itm/Fordson-super-dex...

Hi all

Not having much success in finding a loader manual

Any one able to point me in the right direction please?

Many thanks

Thanks mate !

Morning all Handbrake on my super Dexta isn't staying on It seemed fine when I had the mudguards on, but now I have swapped to the cab ( I can't remember the make, but it has canvas roof and doors ) it won't stay on Is there a different model mechanism for the cab or might it be knackered and replac...

Thanks Bob. That is pretty clear.
Doesn't seem too complicated . Currently I have an arrangement to work a log splitter, which might need to be altered in favour of the loader but I would need an additional hydraulic feed for the grab, as i understand it

Cheers

cheers. I might communicate via S2C (more natural ground for me !)

Hi all. Too late for this year I fear, but what would I need to do to fit a perry bale grab onto the loader of my Dexta ? I have small bales and picking up a stack of 6 or 8 (?) would improve the longevity of my old and worn out back I haven't fitted the loader yet as I want to recon the rams first....

many thanks

Hi again I wonder if you could assist please Super Dexta with kuboto 1.2 flail mower. Works fine other than has decided to jetison the off side pin from the three point linkage, despite having new lynch pins. Obviously I haven't noticed the lynch pin missing until too late and then the pin itself va...

I have been using a kuboto 1.2m (4 ft in real money) flail mower on my Super Dexta, for cutting/topping rushes on my land. Is there a recommended speag / gearing for optimum efficiency ? I have found that 1st, low ratio seems to work well, as the rushes are thick and 2ft tall. Would folk concur with...

I am having similar problems with my superdexta, in that I don't know what the switch does

Which position gives everyting off? vertical ? (with the pivot at the top lever pointing down? )

And from vertical, what then please?

Many thanks
Alex

I have oil leaking from the hub onto the inside of the wheel. The brakes are rubbish so I am pretty certain that the oil seal(s) are in need of replacement, along with the brake linings Other than brake shoes, inner and outer seals and (possibly) bearings, what else will I need ? Any gaskets ? The P...

Cheers Bob
I removed the cover plate and that seemed to "unlock" the levers.
Once I placed it - all was working nicely again

Panic over

I was reversing the dexta gently and stopped with a rear wheel against a gate post. I braked clutch in and attempted to change to a forward gear (low box) Gear lever now stuck in reverse and won't budge Any ideas please? Would jacking it up to get some slack between the gate post and the tractor hel...

Thanks Les

HI My super dexta is reluctant to start at the moment. New battery, but the heater plug cable needs a new spade connector (easy to sort) and the knob doesn't click when pressed in on the injector pump. I was told that it is dependant on the pull stop mechanism somehow Any assistance on resetting the...

Nice and functional

Up here in Yorkshire, I have been planting blackthorn, as we love the sloes to use to make sloe gin

Thanks for the suggestion

I am pretty sure that Undercovers have eclipsed Exmoor in terms of quality nowdays, but def worth a shout

Afternoon all

I was wondering where I might find a source for a replacement lambourne cab hood / canvas.

I have a feeling that they won't be cheap !

Any sources please?

thanks

My superdexta has become a reluctant starter, in that when I press the starter lever, there are clicks but no action. Moving the L/H lever has tended to prompt action but could well be co-incidence or a pointer to something else Any ideas please? I have searched on previous posts but not found anyth...