The Fordson Tractor Pages Forum

Thank you
Regards Mark

Thanks Sandy
The splines on the original one are very poor.
I will keep you posted, did you mean most parts or steering in particular?
Regards Mark

Hi Does anyone have a diagram for dexta wiring that has a five terminal lucas regulator, F,D,E,A and the extra one (A1) my set up also has light switch and key switch combined. I think the five terminal is the older regulator. I am not sure if the isolator key switch being separate or combined is th...

Hi This is where i am with on going steering nut issues. I ordered a new steering nut and bearing kit from a breaker as i was ordering other parts at the time so it made sense. Upon trying to fit i found it wouldn’t start/fit but would go on upside down, up to the last few turns. I contacted and ret...

Hi I thought i had better start with a thank you to all who helped me on replacing my clutch. Prompted by the fact i need advice again, guilty as charged I bought a new one and got it back reasonably stressless. The advice that repairing my old one might be a task too far was followed. Its been an o...

Thanks Gerald

It pains me to run away from a challenge but earlier on today I ordered a new clutch. So you are making me feel a lot better, as you say plenty to do besides the clutch and I am on the bottom of a learning curve, loving it though.
Regards Mark

Thanks again for posting help and information, good news is I have managed to source a breakers who are sending me a new oil seal housing. When that arrives I will decide on new clutch or attempt a clutch rebuild.
Regards Mark

Thank you for the help so far, mulling it all over. Good to know I don't have to waste my time searching for a new housing, I didn't see any second hand ones on the internet either, so I'll try the repair. For most of my working life I had access to a lathe but sadly no more. Psyching up to try the ...

Thanks Sandy Yes the clutch might be a step too far. The oil seal housing, its the actual housing its self that broken, I am hopefully on that but I could not find a new part on agrilines catalogue or other web searches, so a repair might be possible. I have not tried ringing agriline though. I will...

Hi, Has anyone got any advice for me about two stage clutches? The oil seal seal housing between bell housing and the gearbox is broken along the shaft where the thrust bearing runs, I have hopefully got a fix for that. In the mean time I would like to split the two stage clutch to replace the frict...