Search found 5 matches

by Lister Boy
Sat Mar 24, 2018 11:00 am
Forum: Fordson F, N and E27N Major
Topic: E27N Petrol/TVO flywheel removal
Replies: 1
Views: 4701

E27N Petrol/TVO flywheel removal

Hi, I have a E27N pet/TVO engine lying on its side on my garage floor as I needed to remove the clutch and flywheel for a conversion. Removing the clutch is fine; clearly though the flywheel is retained by six pull in bolts and nuts from the engine side. The question is can I undo these 6 by accessi...
by Lister Boy
Tue Jan 03, 2017 11:11 am
Forum: Fordson F, N and E27N Major
Topic: Setting up E27N clutch
Replies: 1
Views: 5030

Setting up E27N clutch

Hi, Looking at resetting / adjusting clutch on a E27N engine. Mechanically it all looks simple to adjust flat and square but, is there a dimension to set the release bearing face to the back of the block? You may well be able to adjust any variation out on the clutch linkage but, as I only have the ...
by Lister Boy
Fri Oct 30, 2015 8:42 pm
Forum: Fordson F, N and E27N Major
Topic: E27N bellhousing bolt hole position drawing for a conversion
Replies: 1
Views: 4527

E27N bellhousing bolt hole position drawing for a conversion

Hi,
Looking at an E27n engine conversion project - does anyone have the bolt hole position information / drawing for the rear of engine to front of gearbox?. I know it is close to an SAE2 specification but it is different.
Mike
by Lister Boy
Thu Oct 01, 2015 1:05 pm
Forum: Fordson F, N and E27N Major
Topic: E27N different cast front wheel - what make?
Replies: 2
Views: 5446

E27N different cast front wheel - what make?

Hi, I've been looking at an e27n to purchase for parts - one of the front wheels is clearly not the usual. It has 4 holes similar to the fordson ones but is generally of a heavier build and has a raised cast 'FH' inside a diamond. What is it? Sorry about poor photos - a bit cramped. Sorry cant even ...
by Lister Boy
Fri Jul 13, 2012 9:25 pm
Forum: Fordson F, N and E27N Major
Topic: Newbie & E27N engine conversion - Lister Diesel
Replies: 1
Views: 5172

Newbie & E27N engine conversion - Lister Diesel

Hi all, Newbie here This looks like to be the place to ask questions regarding Fordson stuff. I'm trying to recreate a conversion that my father was involved in - putting a Lister FR4 diesel (4 cyl water cooled) into a used E27N in the early 50's. In trying to achieve this I have some questions that...