Search found 542 matches

by Jerry Coles
Thu Aug 28, 2008 9:48 pm
Forum: Fordson Dexta
Topic: dexta oil
Replies: 5
Views: 5635

I remember when the British Army changed over to detergent oils. There were hundreds of engine failures as the carbon deposits had kept seals etc working. Along comes detergent oil and cleans out the crud and failures everywhere. Changing a tank engine is a BIG job!

Regards

Jerry near Bath
by Jerry Coles
Thu Aug 28, 2008 9:44 pm
Forum: Fordson Dexta
Topic: super dexta glow plug
Replies: 5
Views: 7531

Terry You don't say where you are in the US but I guess it applies to anywhere where it gets very cold that you must have good condition cold starting kit. Yes the heater plug should obviously get hot but don't forget that the fuel hand pump must work and that the foot valve at the end of the fuel l...
by Jerry Coles
Thu Jul 31, 2008 8:17 pm
Forum: Miscellaneous topics
Topic: Old Sodbury Sort Out - Wroughton 3rd August
Replies: 2
Views: 4309

Old Sodbury Sort Out - Wroughton 3rd August

Is anyone going to the Old Sodbury sort Out on Sunday?
I'm going, could we meet up sometime and put faces and words to this bulletin board members?

Regards

Jerry
by Jerry Coles
Tue Jul 22, 2008 3:13 pm
Forum: Fordson Dexta
Topic: Crippled Dexta
Replies: 7
Views: 7464

Good Fordson Folk
Can I through the Forum offer a big public thank you to Neil Paisnel from Jersey for very kindly sending me a replacement cap.
It is very much appreciated and I can soon be trundling around the North Somerset Lanes without wobbly wheeels!

Jerry Coles
:D
by Jerry Coles
Sun Jul 06, 2008 10:15 am
Forum: Fordson Dexta
Topic: Crippled Dexta
Replies: 7
Views: 7464

Its the small cast cap which retains the end of the radius rod against the gearbox.
I've since had to use my Dexta and apart from driving slowly up the road 'cause of the wheel wobble it can still be driven.

Regards

Jerry
by Jerry Coles
Fri Jul 04, 2008 5:07 pm
Forum: Fordson Dexta
Topic: Crippled Dexta
Replies: 7
Views: 7464

Crippled Dexta

Hi folk Just a small request for help from this great community. Driving up the local roads I noticed that my wheels has started to have a large wobble which was quite unnerving. Crept home and examined steering and front axle and noticed the RH radius rod had some slack in it. Closer examination re...
by Jerry Coles
Mon Jun 02, 2008 7:34 pm
Forum: Miscellaneous topics
Topic: Polarisation of generator
Replies: 9
Views: 13479

Generator Polarisation

Hi Folk A word of caution! You are all assuming that the polarisation is achieved by flashing the Field terminal from the +ve battery post. This is OK for 99.99% of generators BUT! I was asked many years ago whilst in the Army to take a look at a young soldiers car as he had blown up 3 generators an...
by Jerry Coles
Mon May 12, 2008 9:06 pm
Forum: Miscellaneous topics
Topic: Burma Disaster Rotary Assistance
Replies: 1
Views: 3284

Burma Disaster Rotary Assistance

Hi Folk Completly off topic but what a disaster the Burma cyclone is. I am in the Rotary club and we busy packing our club water-survival-boxes ready to be sent as soon as possible to Burma. Take a look at what Rotarians do to help others: http://www.chelwood-rotary.com/ . Take the link to our boxes...
by Jerry Coles
Mon May 12, 2008 8:57 pm
Forum: Miscellaneous topics
Topic: New truck
Replies: 9
Views: 11163

Gosh an AEC! My first Army posting after training was to a Royal Artillery regiment which was equipped with Bofors 40/70 Anti Aircraft guns, FCE7 Fire control Radar sets and Meadows 271/2KVA generators. This was in 1966 and these were still in service until replaced with Leyland 16t gun tractors. Th...
by Jerry Coles
Wed May 07, 2008 9:35 pm
Forum: Fordson New Major
Topic: Strange lever
Replies: 1
Views: 4930

The long straight lever is the gear lever, the vertical silver lever is the hydraulic lift lever.
by Jerry Coles
Sat May 03, 2008 9:05 pm
Forum: Fordson New Major
Topic: wheel wobble
Replies: 4
Views: 8697

Hi Try jacking up the front end to take some of the weight off the steering, axles etc and then try rocking each tyre forward and back and also through the steering wheel. It's how the weight holds things tight so you can't move things by handbut you go down the road and it all starts to wobble. Did...
by Jerry Coles
Sat May 03, 2008 8:32 pm
Forum: Fordson F, N and E27N Major
Topic: E27N restoration questions
Replies: 11
Views: 20929

Hi guys When my E27n headlightd were well and truly rotted I found that motorcyle headlights fitted. Remove the glass from inside the rims by removing the clips and then replace with the motor cycle assembly. This also gave me dipped headlights as a bonus. I believe that although perfect restoration...
by Jerry Coles
Thu May 01, 2008 8:45 pm
Forum: Fordson F, N and E27N Major
Topic: E27N Runs for 1 min and then stops
Replies: 11
Views: 15536

When I owned a Pet/TVO E27N it would do a similar thing. I got it down to rubbish in the bottom of the fuel tank resricting the fuel flow. Try putting a small amount of petrol in the TVO tank (first drain the TVO!) and try starting it switched to the TVO side, if it runs OK then its a fuel restricti...
by Jerry Coles
Mon Apr 21, 2008 9:09 pm
Forum: Fordson Dexta
Topic: Dexta wiring
Replies: 0
Views: 4717

Dexta wiring

Hi Folk I have just finished rewiring my Dexta, this includes an aternator, indicators, rear lights and trailer socket. I'll take some pictures and upload them also. For my tractor pictures and other things take a look at the URl below. If it is of any assistance to anyone I drew the wiring diagram ...
by Jerry Coles
Mon Apr 21, 2008 8:41 pm
Forum: Miscellaneous topics
Topic: A bit about me!
Replies: 2
Views: 4294

A bit about me!

Thought I would add a little history of myself. Interested in old tractors and engine from maintaining generators whilst in the British Army repairing Radio equipment for 22 years. Have owned two E27N's (TVO and L4 diesel), a Major and a Dexta (Current) and a TEA20 thing. Through my friendship with ...
by Jerry Coles
Mon Apr 21, 2008 8:07 pm
Forum: Fordson Dexta
Topic: Cold Starting a Dexta - A novel solution!
Replies: 16
Views: 20984

Cold Starting a Dexta - A novel solution!

Saw this Dexta at Hullavington a couple of years ago and the owner explained how it worked. Lite up a gas blowlamp, open the tap that is plumbed into the inlet manifold, point the flame into the cup and start it!! http://i307.photobucket.com/albums/nn284/JerryColes/Tractor%20Pictures/DSCF0871.jpg T...
by Jerry Coles
Thu Apr 17, 2008 9:43 pm
Forum: Miscellaneous topics
Topic: How do I get to A the old BB, B the main pages?
Replies: 2
Views: 4357

How do I get to A the old BB, B the main pages?

Hi Oscar and Brian
Am I missing it but I cannot find how to go to the old BB pages and to your main page whilst in the BB.
Help please. :(