Fordson N

Fordson N · Post by **Fordson N** » Sun Feb 07, 2016 6:59 pm

First Hello to all,
I hope with you some answers to bekommen.Ich have a Fordson N Bj.1938. It starts and runs great, but after a certain time he goes out, and will not start again after cooling.
Is this due to the hot gas? Air and gasoline remains the same.
Have you a few Info`s? Thanks in advance.
Greeting Dirk

SkidRoe · Post by **SkidRoe** » Thu Feb 11, 2016 2:46 am

You could be experiencing coil break down in the magneto, or a bad condenser. When it does it, check to see if you have spark.

Hope this helps - SR

Fordson N · Post by **Fordson N** » Thu Feb 11, 2016 10:20 pm

Hi, thanks for the Information.ich will the magneto check
greeting Dirk

fordsonf25 · Post by **fordsonf25** » Tue Feb 16, 2016 8:43 am

When it will not start are you able to turn it over by hand? Does it turn smoothly?

Fordson N · Post by **Fordson N** » Sat Apr 23, 2016 5:35 pm

Hi, I have checked the magnet. Coil has a winding end, why he goes out after some time. I'll let wind the coil again.
Thanks for your advice.
Greeting Dirk

oehrick · Post by **oehrick** » Sat Apr 23, 2016 11:41 pm

Well done Dirk - that could cause the problem.

Is the broken wire somewhere that you could solder and then insulate the joint with something like epoxy resin ?

Not a permanent repair but would confirm if this is the only problem.

Fordson N · Post by **Fordson N** » Wed Apr 27, 2016 6:52 pm

The damage is not watching. The coil should rewound werden.Gruß Dirk

oehrick · Post by **oehrick** » Wed Apr 27, 2016 10:49 pm

OK Dirk, hope the repair goes well

Rick

The Fordson Tractor Pages Forum

Fordson N

Fordson N

Re: Fordson N

Re: Fordson N

Re: Fordson N

Re: Fordson N

Re: Fordson N

Re: Fordson N

Re: Fordson N