E 27N P6 check chains Brackets (Australian)
Posted: Tue Jan 22, 2013 12:55 am
Hi,
With the Australian P6 rims with the inner weight ring cast into the rim, the check chain bracket that is bolted to the axle tube it is running very close to the rim.
I see in books that the bracket can be drilled with a third hole much higher which will clear the inner ring weight area, as the ones i have only two holes and run in the area of the inner cast weight area.
Can some one supply pictures or measurments of where the third hole is to be drilled in the brackets &/or are the brackets different to the std e27n tractors here in Australia.
Any information would be helpful.even a picture of the brackets fitted to a Australian P6 to see the mounting arrangement.
Thanks, Willsy
With the Australian P6 rims with the inner weight ring cast into the rim, the check chain bracket that is bolted to the axle tube it is running very close to the rim.
I see in books that the bracket can be drilled with a third hole much higher which will clear the inner ring weight area, as the ones i have only two holes and run in the area of the inner cast weight area.
Can some one supply pictures or measurments of where the third hole is to be drilled in the brackets &/or are the brackets different to the std e27n tractors here in Australia.
Any information would be helpful.even a picture of the brackets fitted to a Australian P6 to see the mounting arrangement.
Thanks, Willsy