I'm ready to replace the sump on my E27n after a bearing adjustment and ring replacement.
Is there meant to be a gasket between the rear vertical face of the sump and the bell housing, or just the two long sides?
Sump Gasket
Re: Sump Gasket
Hi,
You"ll certainly need a gasket there. Trust cut one in gasket paper and a little liquid gasket on both sides to make a sure seal.
Also check the rope seal in front before remounting.
Rgds
You"ll certainly need a gasket there. Trust cut one in gasket paper and a little liquid gasket on both sides to make a sure seal.
Also check the rope seal in front before remounting.
Rgds
Best regards
Emiel
N 1937, E27N 1948, 8N 1949, E27N 1950, E1A Diesel 1953, E1ADKN PP 1956, Dexta 1959, NH Clayson M103 1964
Emiel
N 1937, E27N 1948, 8N 1949, E27N 1950, E1A Diesel 1953, E1ADKN PP 1956, Dexta 1959, NH Clayson M103 1964
-
- Not Quite Blue Yet
- Posts: 18
- Joined: Tue Apr 08, 2014 6:28 am
- Location: Warncoort, Victoria. Australia
Re: Sump Gasket
Thanks Emiel, I thought it needed one . The parts list shows the two long side gaskets but not the vertical one.
But you are right and I will do as you suggest.
Bob
But you are right and I will do as you suggest.
Bob