Page 1 of 1
Fordson N
Posted: Sun Feb 07, 2016 6:59 pm
by Fordson N
First Hello to all,
I hope with you some answers to bekommen.Ich have a Fordson N Bj.1938. It starts and runs great, but after a certain time he goes out, and will not start again after cooling.
Is this due to the hot gas? Air and gasoline remains the same.
Have you a few Info`s? Thanks in advance.
Greeting Dirk
Re: Fordson N
Posted: Thu Feb 11, 2016 2:46 am
by SkidRoe
You could be experiencing coil break down in the magneto, or a bad condenser. When it does it, check to see if you have spark.
Hope this helps - SR
Re: Fordson N
Posted: Thu Feb 11, 2016 10:20 pm
by Fordson N
Hi, thanks for the Information.ich will the magneto check
greeting Dirk
Re: Fordson N
Posted: Tue Feb 16, 2016 8:43 am
by fordsonf25
When it will not start are you able to turn it over by hand? Does it turn smoothly?
Re: Fordson N
Posted: Sat Apr 23, 2016 5:35 pm
by Fordson N
Hi, I have checked the magnet. Coil has a winding end, why he goes out after some time. I'll let wind the coil again.
Thanks for your advice.
Greeting Dirk
Re: Fordson N
Posted: Sat Apr 23, 2016 11:41 pm
by oehrick
Well done Dirk - that could cause the problem.
Is the broken wire somewhere that you could solder and then insulate the joint with something like epoxy resin ?
Not a permanent repair but would confirm if this is the only problem.
Re: Fordson N
Posted: Wed Apr 27, 2016 6:52 pm
by Fordson N
The damage is not watching. The coil should rewound werden.Gruß Dirk
Re: Fordson N
Posted: Wed Apr 27, 2016 10:49 pm
by oehrick
OK Dirk, hope the repair goes well
Rick
