Setting up E27N clutch
Posted: Tue Jan 03, 2017 11:11 am
Hi,
Looking at resetting / adjusting clutch on a E27N engine. Mechanically it all looks simple to adjust flat and square but, is there a dimension to set the release bearing face to the back of the block?
You may well be able to adjust any variation out on the clutch linkage but, as I only have the engine I want to set it to 'Factory'
Is this information in any of the literature / workshop manual?
thanks Mike
Looking at resetting / adjusting clutch on a E27N engine. Mechanically it all looks simple to adjust flat and square but, is there a dimension to set the release bearing face to the back of the block?
You may well be able to adjust any variation out on the clutch linkage but, as I only have the engine I want to set it to 'Factory'
Is this information in any of the literature / workshop manual?
thanks Mike