Unload valve
-
woodcutter
- True Blue
- Posts: 198
- Joined: Tue Oct 18, 2011 10:34 pm
- Location: hereford
Unload valve
I’ve just took the lid off my super major and valve was stuck so now it’s removed the oring is no good what’s my best option can I just put it back in with out oring will it all work ok? or try to find an oring
-
mathias1
- Site Governance Team
- Posts: 809
- Joined: Fri Jul 08, 2016 7:11 pm
- Location: Antwerp - Belgium
Re: Unload valve
Hi,
somewhere on the forum Brian advised it's better to leave of the o-ring. I've done this also and the hydraulics did work without it.
somewhere on the forum Brian advised it's better to leave of the o-ring. I've done this also and the hydraulics did work without it.
Fordson Super Major New Performance
County Super 4 built on the Fordson Super Major
Selene built on the Fordson Super Major New Performance with Silvant winch
County Super 4 built on the Fordson Super Major
Selene built on the Fordson Super Major New Performance with Silvant winch
-
woodcutter
- True Blue
- Posts: 198
- Joined: Tue Oct 18, 2011 10:34 pm
- Location: hereford
Re: Unload valve
Ok thanks valve still seems sticky, when pushed right in but smooth until it gets up to the end