The Fordson Tractor Pages Forum

Hi all, im currently rebuilding the gearbox in my major. ive managed to source some new bearings and stuff but stuggling to find a pto seals. (the one that the exention shaft runs through). The seal is a double lip seal and has a metal caseing all built around it. i was also wondering is there any seals in the input shaft in the gearbox to change?? the splined shaft.

I was also thinking of changing the cylinder roller, far right aswell does anyone know where these can be sourced in the uk?

ID=54mm OD=87mm width =20mm

If anyone could put me onto where to get there that would be great, i tryed agriline but as you can see from the photo it appears to have shrunk in the wash!!

many questions again but im sure you guys will put me stright

many thanks dan.

Dunlop tractor parts have all the seals you need ,just give them the dimensions .I got all my seals from them ,they are good people to deal with and know their stuff. Liam .

thanks liam il give them a ring monday, do you know if there is a seal in the gearbox input shaft the splined one the clutch goes onto? im wondering if i should be doing that one aswell to stop oil contamination on the clutch.

cheers dan,