FSM HYDRAULIC PUMP

This forum is for the Fordson New Major, including the Super Major and the Power Major.
Post Reply
kissamo
Not Quite Blue Yet
Posts: 21
Joined: Tue Apr 16, 2019 8:27 am

FSM HYDRAULIC PUMP

Post by kissamo »

Dear FORDSON enthusiasts;

May i know what is the specifications of the FSM Hydraulic pump.
Oil flow vs rpm.

Rgds
Elias

Billy26F5
True Blue
Posts: 1913
Joined: Fri Jun 26, 2020 12:01 am
Location: On Billy

Re: FSM HYDRAULIC PUMP

Post by Billy26F5 »

4.93 gal/min at 1600 rpm, at 2500 psi.
Sandy
ImageImageImage

kissamo
Not Quite Blue Yet
Posts: 21
Joined: Tue Apr 16, 2019 8:27 am

Re: FSM HYDRAULIC PUMP

Post by kissamo »

DEAR SANDY

THANKS FOR YOUR REPLY. I contacted the supplier (WHITE HOUSE PRODUCTS LTD) of the pump and this is what he said;

'The fordson major pump has a capacity of 20cc/rev. Therefore if you multiply the capacity by the rpm of the pump shaft divided by 1000 then you will get the flow in litres per minute. Pump Flow (litres per minute) = capacity (cc/rev) x RPM/1000'

Going by this figure at 1600RPM i get at;
pump flow (litres/min) =20 x 1600/1000 = 32litres/min equivalent to 8.4gal/min

Any comments sandy

Rgds
Elias

Billy26F5
True Blue
Posts: 1913
Joined: Fri Jun 26, 2020 12:01 am
Location: On Billy

Re: FSM HYDRAULIC PUMP

Post by Billy26F5 »

Bear in mind repro parts are in the land of nearly right, which would explain the difference between your supplier and the original specification.
Sandy
ImageImageImage

mathias1
Site Governance Team
Site Governance Team
Posts: 787
Joined: Fri Jul 08, 2016 7:11 pm
Location: Antwerp - Belgium

Re: FSM HYDRAULIC PUMP

Post by mathias1 »

Is the pump turning on the same speed as the engine?

You should count the teeth on the pto shaft and calculate from there I guess.
Fordson Super Major New Performance
County Super 4 built on the Fordson Super Major
Selene built on the Fordson Super Major New Performance with Silvant winch

Billy26F5
True Blue
Posts: 1913
Joined: Fri Jun 26, 2020 12:01 am
Location: On Billy

Re: FSM HYDRAULIC PUMP

Post by Billy26F5 »

Remember the PTO shaft turns at 540 rpm for 1200 rpm of the engine except the NP Super Major that does 540 rpm for 1500 rpm of the engine. The PTO to pump ratio is 33/21 except for the NP Super Major that has 34/18.
Sandy
ImageImageImage

Post Reply