Diff housing to gearbox New performance major
Posted: Mon Feb 26, 2024 11:54 am
Hi,
I am in the process of rebuilding the diff and bevel gear housing due to it being stood for a while and the diff is seized. The diff housing was tight to remove from the gear box and during removal we saw a clamp of the output shaft from the gear box.
We slackened off the clamp and the back end housing was easier to remove. I am not sure why this made it easier, as I cant see any reason why slacking the clamp should loosen the shaft?
Is there a procedure for tightening the clamp, how do I access the service manual to view this?
Many thanks
I am in the process of rebuilding the diff and bevel gear housing due to it being stood for a while and the diff is seized. The diff housing was tight to remove from the gear box and during removal we saw a clamp of the output shaft from the gear box.
We slackened off the clamp and the back end housing was easier to remove. I am not sure why this made it easier, as I cant see any reason why slacking the clamp should loosen the shaft?
Is there a procedure for tightening the clamp, how do I access the service manual to view this?
Many thanks