Page 1 of 1
crank handle measurements
Posted: Wed Apr 29, 2009 6:33 pm
by MAXPOWER
Hello--- since my search for a crank handle has not bore any fruit does anyone have one they can measure for me so i can have one made?
thanks in advance!
Posted: Thu Apr 30, 2009 4:58 am
by Miles
Hope this helps...
Can anyone confirm this is original fordson issue?
Regards
Posted: Thu Apr 30, 2009 7:37 am
by Brian
Yes.
Posted: Thu Apr 30, 2009 4:27 pm
by Kjetil
Something is missing.
You need a peace of steel going through the hole in the front.
Mine is different, maybe not original.
I will se if I rember to take a picture.
Kjetil
Posted: Thu Apr 30, 2009 8:16 pm
by Brian
The shaft is usually part of the tractor not the handle on Majors.
Posted: Fri May 01, 2009 4:32 pm
by MAXPOWER
Miles thanks can you please verify the square opening? i thought it was 3/4 inch looks bigger in your pictures?