Page 1 of 1
ransomes combine engine
Posted: Sun May 17, 2009 10:50 pm
by wee blue tractor fan
hi there i have been storing a perkins 4236 engine from a ransomes combine for a good few years with the intention of fitting it to a major back end the bell housing looks the same and i was wondering if any body had done this and if any body had any advice
Posted: Mon May 18, 2009 7:24 am
by Brian
Please don't !
No Major deservs to go through the final years of its life with a Ferguson based engine!
Seriously though, the 6354 was a very good engine but you would need an adaptor plate to fit it to the Major clutch housing. Such plates were made in the early days when the TVO engines were removed and Perkins L4 engines fitted.
It would be a nice interesting engineering job.
Posted: Tue May 19, 2009 10:12 pm
by Emiel
Hello,
Some people have comparable ideas.
Read this:
http://farmingforum.co.uk/forums/showthread.php?t=11664
Best regards
Emiel
Posted: Wed May 20, 2009 8:11 am
by Brian
I may be going to upset some people now! I would rather have a 6354 any day than a Merc.!
I drove the same model of combines with both and felt that the Merc engine were overated. I also had a Merc 5 cylinder in a car and it was one of the worst engines I have ever come across.
The idea about the flywheel is interesting. Roadless fitted a similar idea to some of their tractors. It looked like a cotton reel that thread for sewing comes on and was very heavy.