Wanting to get a hydraulic system on my dexta.
Posted: Mon Mar 30, 2009 10:02 am
Wanting to get a hydraulic system on my dexta.
Having checked a few sites and pictures, and I have got a few questions about the hydraulic system and about the controls of it.
From one of the pictures see below, the hydraulic supply connection is in front of the seat and is than lead to where ever is has to go.
The next thing is the return of the oil, where is the connection for that, so it comes back to the correct place. Have seen a picture where it goes back to the rear axle and differential, is this correct?
Now I have a few additional questions about the control of the system.
Immediately above the supply point there is the spindle restrictor control, where is this for?
( I got the name spindle restrictor from a part listing).
Immediately next to the supply there is a knob, do I need to pull this or push it to use the hydraulic system?
Than on the side of the hydraulic system under the seat there is the lever controller selector. What is this for?
Have some pictures here to illustrate the question, but for some reason I cannot get them up loaded.
Any more tips are very welcome. thanks
Having checked a few sites and pictures, and I have got a few questions about the hydraulic system and about the controls of it.
From one of the pictures see below, the hydraulic supply connection is in front of the seat and is than lead to where ever is has to go.
The next thing is the return of the oil, where is the connection for that, so it comes back to the correct place. Have seen a picture where it goes back to the rear axle and differential, is this correct?
Now I have a few additional questions about the control of the system.
Immediately above the supply point there is the spindle restrictor control, where is this for?
( I got the name spindle restrictor from a part listing).
Immediately next to the supply there is a knob, do I need to pull this or push it to use the hydraulic system?
Than on the side of the hydraulic system under the seat there is the lever controller selector. What is this for?
Have some pictures here to illustrate the question, but for some reason I cannot get them up loaded.
Any more tips are very welcome. thanks