Page 1 of 1
WANTED: Axle pin retainer
Posted: Mon Feb 08, 2010 8:06 pm
by marcusgs
Hi,
Does anyone have a spare axle pin retainer?
I am missing mine and someone has replaced the original pin with one from a ferguson!
I would like to return it to original.
Thanks,
Posted: Tue Feb 09, 2010 8:22 am
by EddieJ
This is for a dexta right? I was following your other thread about this.
Our axle is currently in pieces and can get you photos and dimentions for you to make one if thats any help? A small piece of flat plate and some cutting, a drilled hole and your done.
You could always try a breakers if your in desperate need of an original piece.
Posted: Tue Feb 09, 2010 12:08 pm
by Bensdexta
EddieJ wrote:You could always try a breakers if your in desperate need of an original piece.
Worth trying Malcolm Hipperson too.
All the best,
Posted: Tue Feb 09, 2010 6:11 pm
by marcusgs
Hi EddieJ,
Yes some photo's and dimensions would be great, thankyou in advance...
Regards,
Posted: Thu Feb 11, 2010 5:56 pm
by EddieJ
marcusgs wrote:Hi EddieJ,
Yes some photo's and dimensions would be great, thankyou in advance...
Regards,
Some images, technical drawing and measurments to follow:
Posted: Thu Feb 11, 2010 6:18 pm
by EddieJ
The large radius is there simply to alow a starting handle to pass through the pivot pin to engage with the starter dog and so is not really necessary and its omission would simplyfy the fabrication job a lot. The original is pressed from mild steel but if I were making it I would try to get hold of a piece of BDMS.
Posted: Fri Feb 12, 2010 1:43 pm
by marcusgs
Hi EddieJ,
Many thanks for that.
Regards,
