Page 1 of 1
Horndraulic loader
Posted: Sun Feb 28, 2010 2:34 pm
by Ian
Does anyone know where you can get replacement seals for these ? We had one of the rams actually remade, but it cost a fair amount .. the other weeps somewhat, and I would like to just replace the seal. It has a bolt on the side to hold it in, but the cap is threaded and just screws on I believe.
Posted: Mon Mar 01, 2010 7:54 pm
by fenhayman
Ian, Where are you?
I've had a ram rebuilt in Norfolk UK. Can give details if relevant.
Posted: Tue Mar 02, 2010 1:59 pm
by Ian
Don't really want another ram rebuilt. The other one cost £300 to have done. Really was just after some new seals for the end if that was possible.
Posted: Tue Mar 02, 2010 3:56 pm
by Bensdexta
Ian wrote:Don't really want another ram rebuilt. The other one cost £300 to have done. Really was just after some new seals for the end if that was possible.
Can you not get a seal kit from the co that rebuilt your ram?
All the best,
Posted: Wed Mar 03, 2010 1:08 pm
by Supertractorman
Would think it could be worth contacting your local hydraulic fittings agent in Yellow Pages as they normally know where to get these items.
Posted: Thu Jul 08, 2010 10:04 pm
by fenhayman
I've got an earlier version, without the ram that tips the bucket. Got a weeping ram repaired two years ago in Norfolk UK for about £25.
Aren't the 'locking bolts' bleed screws to let any air out?
Mail me if you are close
Posted: Wed Jul 28, 2010 1:03 pm
by Ian
the extra ram was one of our DIY modifications for attachments that needed to be tilted.