McConnel saw bench

Hesford · Post by **Hesford** » Sun Jan 27, 2013 6:19 pm

Hi all recently bought a saw bench to use behind my MK1 E1A just not quite sure how to use it, like engine speeds ect any advice great fully appreciated

Ash

chriss · Post by **chriss** » Sun Jan 27, 2013 11:04 pm

i ran mine just above tickover but the blade needs to be sharp and a decent set on it

tom lad · Post by **tom lad** » Tue Jan 29, 2013 10:47 am

hi
mine has the flat belt , it cuts best at about 1600 + rpm from memory .
found that cuts better than at a 1500
very gd tool .

Hesford · Post by **Hesford** » Wed Jan 30, 2013 1:02 pm

Thank you both will try him out once I bring it home should be this weekend!

tom lad · Post by **tom lad** » Mon Feb 04, 2013 9:54 am

does the top sliding forward / back and blade fixed ? photos would be interesting m8 .

Hesford · Post by **Hesford** » Mon Feb 04, 2013 9:58 pm

Brought him home Saturday will try and up load pictures some how!

Hesford · Post by **Hesford** » Mon Feb 04, 2013 9:58 pm

Brought him home Saturday will try and up load pictures some how! And sliding bed

The Fordson Tractor Pages Forum

McConnel saw bench

McConnel saw bench

Re: McConnel saw bench

Re: McConnel saw bench

Re: McConnel saw bench

Re: McConnel saw bench

Re: McConnel saw bench

Re: McConnel saw bench