The Fordson Tractor Pages Forum

Hi all recently bought a saw bench to use behind my MK1 E1A just not quite sure how to use it, like engine speeds ect any advice great fully appreciated

Ash

i ran mine just above tickover but the blade needs to be sharp and a decent set on it

hi
mine has the flat belt , it cuts best at about 1600 + rpm from memory .
found that cuts better than at a 1500
very gd tool .

Thank you both will try him out once I bring it home should be this weekend!

does the top sliding forward / back and blade fixed ? photos would be interesting m8 .

Brought him home Saturday will try and up load pictures some how!

Brought him home Saturday will try and up load pictures some how! And sliding bed