Page 1 of 1

Fixing an old Krone 3500 harvester

Posted: Sat Sep 03, 2011 8:35 pm
by Oscar
Was asked to lend a hand to fix this:

Image

This is (or rather: was) the main bearing of the shaft that drives the harvester's grass pick-up and transport system. It literally burned/grinded itself away. Working on these old Krone harvesters is not a pleasant job. Much to my surprise, it all came apart quite easily - had not expected that given that this thing is >20 years old and the bearing has never been replaced before. Now off to find a new one and then put the whole thing back together again.

Regards,
Oscar

Re: Fixing an old Krone 3500 harvester

Posted: Sun Sep 04, 2011 10:51 am
by Pascal
Hi Oscar,

Looks like a great job..especially when everything comes off quite easily. ;)
Do you have a picture of the complete harvester?

Have fun putting it all together again

Re: Fixing an old Krone 3500 harvester

Posted: Sun Sep 04, 2011 4:06 pm
by Oscar
Hi Pascal,

I did not take a picture of the whole thing, but if you Google for Krone 3500 you'll see a gazillion of them. The picture I posted is how it looked after we took the covers off, so we hadn't really begun yet. This is how it came off the field! It was running so hot that the grass almost caught fire and it had to be dosed with water..

Regards,
Oscar

Re: Fixing an old Krone 3500 harvester

Posted: Mon Sep 05, 2011 3:02 pm
by Dandy Dave
Lack of lube...eventually the grease dries out of a liftime lubed bearing. It is amazing they last as long as they do. Looks ike your going to have to use the fire wrench to split that old bearing center. I have found that most of the time these jobs are not as bad as they look. Dandy Dave!