Super Six Driveshaft reassembling
Posted: Tue Oct 07, 2014 8:06 pm
Hello to all
I will reassembling the driveshafts on my super 6,but what is the right position/"timing"/
for the universal joints?
is this the right solution??? or is there another importend for the reassembling??
in the partslist is a drawing that shows 90degres turned u-joinds.
i`m a little confused about the shafts,their splines are very worned out.
whats your opinion/thoughts about this /
and here is the tractor on first testrun ( with replaced engine out of a combine,and without the shafts)
mbg Jan
I will reassembling the driveshafts on my super 6,but what is the right position/"timing"/
for the universal joints?
is this the right solution??? or is there another importend for the reassembling??
in the partslist is a drawing that shows 90degres turned u-joinds.
i`m a little confused about the shafts,their splines are very worned out.
whats your opinion/thoughts about this /
and here is the tractor on first testrun ( with replaced engine out of a combine,and without the shafts)
mbg Jan