Some holes in the front end.
![Image](http://i804.photobucket.com/albums/yy330/ianposkitt/tinworkcrop_zpsc938d8d0.jpg)
As purchased except I have shot blasted the wheels and repainted + new tyres.
![Image](http://i804.photobucket.com/albums/yy330/ianposkitt/DSCF6891_zps9caf36b0.jpg)
The fuel tank had been leaking for years, making a mess of the electrics but at least preventing rust in this area.
![Image](http://i804.photobucket.com/albums/yy330/ianposkitt/DSCF6899_zps060abdd6.jpg)
![Image](http://i804.photobucket.com/albums/yy330/ianposkitt/20140222_115408_zps57a8e62b.jpg)
I tried to repair the tank with soft solder but found it wasn't the seam that was leaking, it was loads of tiny pin holes. Help from a previous post directed me to use "Slosh" which seems to have worked. Mind you I haven't put any diesel in it yet.
![Image](http://i804.photobucket.com/albums/yy330/ianposkitt/Tank3LoRes_zps34e0b71e.jpg)
The dynamo was worse than I expected, the field winding had burned out and the armature didn't look too good either, I bought replacements for both and cleaned and painted the case.
![Image](http://i804.photobucket.com/albums/yy330/ianposkitt/DSCF7078_zps6c2ea86a.jpg)
Connections soldered to original terminals.
![Image](http://i804.photobucket.com/albums/yy330/ianposkitt/DSCF7084_zps9d3c0ac1.jpg)
Bearing and spacers etc for pulley end.
![Image](http://i804.photobucket.com/albums/yy330/ianposkitt/DSCF7124_zps079ff45a.jpg)
Just helping the circlip to expand fully into its groove. The dynamo is assembled and tested. the regulator however is soaked in Diesel! I'll come to that later.
![Image](http://i804.photobucket.com/albums/yy330/ianposkitt/DSCF7135_zps7223f033.jpg)
I have cleaned and sprayed a lot of parts but didn't have the camera out, blue finger prints on the camera would get me into trouble. I'll post some more when I can.
Regards
Ian