Help with serial number and age

[6k-ranch]

Hi,
i am a new here. I run in a problem two of my pushbars for my valves are bend and i do need new one. i have no idea where i get them and the local dealer (new holland) tried to help me but to find proper part i do need find some information about my tractor (age) and motor.
i found a few no on my tractor but i dont have no idea how to read them.
thats the no i found:
on my injector pump: SPE 4A 75s647
left under injector pumo on motor : EIADKN6015
T3
Under the seat: EIADDN 501
and left side close to jont motor and transmision: D61d (but the first D looks back to the front)

Hope does anyone can help me or give me more ideas where i can find more information about my tractor or where i can finde more numbers on the tractor soi can order the right parts.
thanks a lot allready

[Dandy Dave]

Look here... http://www.fordsontractorpages.nl/manua ... _major.pdf Dandy Dave!

[6k-ranch]

thanks for the link.
there are two more spots to look. but how can i read the numbers the letter number code? what does the numbers mean which i allready found?
i looked into some post but maybe i mist the one with the decoding

[6k-ranch]

After reading diffrent posts i found some nr on my tractor but i still have trouble to decode them to a proper Date.

This is what i found:

on my is telling me Fordson Super Major
under injector: EIADKN6015 E
under it little left T3

near clutch link (look up side down): P19(8?)D (think so look it right)

Near generator: A6F

under seat EIDDN 501

on my injector pump: SPE 4A 75S647

hope anyone can help me out to find a age from my tractor with all this codes

[Gman]

Hello 6k. The numbers you list look like part numbers and casting codes, not serial number. Look at Dave's picture as to where the serial number is on your tractor. A picture of your tractor would help. Look at the home page on this site, bottom left and there are listings of numbers, manuals etc. Good luck.

[Pavel]

It will help you to find the important serial numbers by looking for numbers that have been STAMPED onto a machined surface [usually above the starter motor or near the injectors] and not the raised casting numbers and letters.

Pavel

[6k-ranch]

Finaly i found a number behinde the injector pump.
hope read it right : 1585931
i tried to match it with some of this lists but i could not.
hope some can help me i can try to make a pic from it if that help.
Thanks

[chriss]

Could be jan 1961

[6k-ranch]

Thanks. I think thats bring me closer to my push rods