oil leak

super6 · Post by **super6** » Tue Jun 30, 2009 8:30 pm

when i stripped my diesel major hydraulics i took apart the lift lever as it leaked and was very gungy.
having put a new seal on rear of pin that holds lift and lower lever, i still have a good leak from where pin comes out of ally casing on the front side, there is no seal or o ring on this side so how can i stop it leaking.
thanks in advance brett

henk · Post by **henk** » Tue Jun 30, 2009 9:07 pm

Hello Super6,

Thats the only O-ring there is to it. Could it be that the hole is worn to much?

super6 · Post by **super6** » Tue Jun 30, 2009 9:11 pm

i guess that can be only problem , but not sure quite how to solve the problem, i dont think instant gasket will work as the pin is always moving back and forth.

henk · Post by **henk** » Wed Jul 01, 2009 5:38 pm

Hello Super6,

Don't know if you are able to (or let) machine the hole and make a new bush. You can glue that in with loctide.
If not than try to find a used part.